I reconnected my Bravia X-Series panel you.Press Source button to have the monitor double-check the input signal source.Download Now SAMSUNG MONITOR 226BW DRIVER If you connect properly your monitor using the DVI connector but get a blank or fuzzy screen, check to see if the monitor status is set to analogue. You may get a blank screen depending on the type of video card you are using, if you connect simultaneously both the D-sub and DVI cables to one computer. If your monitor displays an image, installation is complete. In the case of an old model Macintosh, you need to connect the monitor using a special Mac adaptor.ĥ. Using the DVI (Digital) connector on the video card.Ĭonnect the DVI Cable to the DVI Port on the back of your Monitor.Ĭonnect the monitor to the Macintosh computer using the D-SUB connection cable.Ĥ.
Using the D-sub (Analogue) connector on the video card.Ĭonnect the signal cable to the 15-pin, D-sub connector on the back of your monitor.Ģ-2.
Plug the power cord for the monitor into a nearby outlet.Ģ-1. Connect the power cord for your monitor to the power port on the back of the monitor. For energy conservation, turn your monitor OFF when it is not needed, or when leaving it unattended for long periods.ġ. Note: See PowerSaver described in the manual for further information regarding power saving functions. Power indicator This light glows green during normal operation, and blinks green once as the monitor saves your adjustments. Message appears in the center of the screen displaying the current mode - analog or digital input signal.)Ħ. Power button Use this button to turn the monitor on and off.(When the power is turned on, a
Menu button Use this button to open the OSD and activate a highlighted menu item.ĥ. Adjust buttons These buttons allow you to highlight and adjust items in the menu.Ĥ. Note:If you select the Digital mode, you must connect your monitor to the graphic card with a digital port using the DVI cable.ģ. (When you push the Source button to change the input source or turn on the monitor, a message appears in the center of the screen displaying the current input source - analog or digital.) Source button When you push the Source button while the OSD is off, the input source (analog/digital) is alternated. Exit button Use this button to Exit the active menu or the OSD. Auto button Use this button to auto adjustment direct access.Ģ.
0 kommentar(er)
